The Sunny Plumber Phoenix Blog : Archive for the ‘Heating’ Category

How to Make Your Water Heater Last Longer

Monday, November 30th, 2015

Water heaters are quite sturdy systems, and they can last a long time with proper care and maintenance. They won’t last forever, though. You can severely shorten your water heater’s lifespan if you don’t make sure to treat it properly. Fortunately, there are some things you can do to make sure that your water heater lives a full and productive life. Read on to find out how you can make your water heater last as long as possible.

Continue Reading

Help! My Water Heater Isn’t Supplying Enough Hot Water!

Wednesday, December 10th, 2014

One of the most common problems with water heaters that can leave homeowners scrambling for professional service is when there is inadequate heating from the unit.

Hot water is vital for many of the tasks you perform around the house on a daily basis. So if you aren’t getting enough hot water or if you notice bursts of hot and cold, you may fear the worst: that your water heater will soon break down and require replacement. Fortunately, this isn’t always the case.

Check out three of the most common reasons water heaters fail to dole out an adequate supply of hot water:

  • Broken Dip Tube: The dip tube is a long bit of pipe that leads to the bottom of the tank and connects to the cold water supply lines. Cold water moves to the bottom, where an electric heating element or gas burner heats it up. Then, the hot water naturally rises over the colder, denser water. If this piece is broken or cracked, cold water will remain around the top of the tank, leading to cold spurts of water or insufficient heating. A technician will usually simply replace this component.
  • Burner Trouble: One of the reasons you may not feel enough hot water is if there is a problem with the burner or electric heating element. The burner may be getting too much gas or not enough gas delivered to the unit, or condensation may drip onto the burner. With electric elements, you may simply not have enough power to the unit.
  • Improper Sizing: Unfortunately, sometimes a water heater acts up because it was not sized properly, which could mean a new system is your best bet. If your water heater is too small for the home, it won’t be able to supply enough hot water to meet higher demands. However, a unit that is too large costs a lot to install and run, which is why it’s important to choose trained professionals for installation. An experienced installer will make sure it’s the proper size for your needs, which involves careful calculations and planning.

When you sense water heater trouble, don’t expect the worst right away.

Call on the technicians at The Sunny Plumber who can help you decide if replacement is ultimately the best option or if your system can be up and running again with professional water heater repair in Gilbert, AZ.

Continue Reading